Anhui Qisong Machinery & Vehicle co.,ltd.

Wheel loader lubrication and maintenance considerations

1, the oil must be clean, diesel must be 72 hours of precipitation; hydraulic system cleanliness must meet 18/15 (GB/T14039). Otherwise, the stem could easily lead to excessive wear and pump seizure.

2, oiling and oiling parts must be clean.

3, check the oil level must be to make the machine state.

4, front and rear axle oil filling hole injection from the left and right wheel joined to the axle housing until the oil level plug at the overflow.

5, the transmission of oiling: oil tube to the transmission oil, gearbox oil standard middle position to start the machine, and idle for 5 minutes, at any time to add oil, the oil is stable in the oil standard middle position.

6, hydraulic oil tank of fuel injection: Open the hydraulic tank cap, fuel to the fuel tank, oil tank when the oil level reaches the middle position can be marked; for the first time the hydraulic tank to the engine should start running again after 5 minutes check the oil level.

7, a variety of oil may not mix, alternative, otherwise it will result in failure of the aging of rubber parts, parts premature wear.

8, must be specified in the procurement mighty filter, oil filter spare parts.

9, must be specified by the mighty oil product specification grades.

10, add fuel or lubricating oil should pay attention to:

No smoking, immediately wipe the spilled fuel, lubricating oil, antifreeze or cleaning fluid. Tighten the fuel tank, sump, add antifreeze box cover.

Filling in a well ventilated place fuel, oil, antifreeze.

11, have been working device at high pressure oil should pay attention to:

Completely prohibit the release of internal pressure before the fuel, put the oil, such as the high pressure oil leaking from the hole, hit by high-pressure spray of liquid will be the skin or eyes, so should wear protective glasses and thick gloves and use cardboard or wood check with oil leakage. If the high pressure oil damaged, seek immediate medical attention.

12, high temperature, high pressure state should pay attention to maintenance:

The machine has just stopped, the engine coolant and oil components are in the high temperature and high pressure. In this case, such as opening the lid drain, replace the filter can lead to burns or other injuries, should wait until after declining oil or water, for maintenance.

13, waste treatment

Do not waste oil into drains or rivers. The waste oil discharged into the container directly into the ban to the ground. Processing oil, fuel, filters and other hazardous materials to comply with relevant laws and regulations when.

14, the technical maintenance of the engine with the engine randomly see "Using the Maintenance Manual."

15, transmission oil replacement operation

The vehicle parked on a level place, the transmission at operating temperature drain the old oil, torque converter and radiator while the oil discharge clean.